Sold Out $200.00
|Fitment||2005-2007 Mazda 6 MPS - Requires Modification|
Please contact for Sydney Pick up.
Minor modification (Trimming edges) is required to Mazda 6 MPS. Please note, the front lip is made for wrx, but has the same curved shaped to fit on this bumper.
Comes in black matte plastic colour. The front lip can be used as is or painted.
Easy Installation. You will need to drill holes for all Polyurethane front lips like this. Instructions not included.
We do not bend or fold our lips when we send them out. However, if you do receive your lip that is distorted because of shipping, do not panic. Please use a heat gun on the affected area and bend it back into shape. Our Polyurethane (PU) front lips have qualities that allows for bend and flex. This process is also possible by leaving it out in the sun for a couple hours prior to fitting.
If you would like to confirm you are purchasing the correct part/accessory suitable for your car, please do not hesitate to contact us.
We recommend a professional to install at all times but here’s a general installation guide:
Fit the front lip onto the bumper of your car to know where and how it lines up. Once you are comfortable with how it sits you can prep for painting if needed (sand, primer, etc).
We recommend you use 3M double-sided tape (not included) for a firmer hold. Sand down the inner edges of the lip (where the lip and car will touch) and then re-clean that area. Apply 3M double-sided tape to where you just sand down and fit the lip onto the car.
After the front lip is mounted, use a heat gun or hair dryer over the whole lip. The heat will help the polyurethane lip mould onto your car for a glove like fitment. Once you’re satisfied with how it is, use the screws provided underneath and on the sides of the bumper.